Boonton 4500B Peak Power Meter Manual do Utilizador descarregar pdf (Página 302)

Boonton 4500B RF Peak Power Analyzer

Remote Operation

5-102

Table 5-1. SCPI COMMAND SUMMARY (continued)

FETCh[1|2|6|7]:INTERval:PKAVG? Return peak to average power between MK1 and MK2.

FETCh:KEY? Return code of last key depressed

FETCh[1|2|3|4|5|6|7]:MARKer[1|2]:AVERage? Return current reading at the specified marker.

FETCh[1|2|3|4|5|6|7]:MARKer:DELTa? Return difference between MK2 and MK1.

FETCh[1|2|3|4|6|7]:MARKer[1|2]:MAXimum? Return maximum reading at the specified marker

FETCh[1|2|3|4|6|7]:MARKer[1|2]:MINimum? Return minimum reading at the specified marker

FETCh[1|2|3|4|5|6|7]:MARKer:RATio? Return ratio between MK2 and MK1 as a percentage.

FETCh[1|2|3|4|5|6|7]:MARKer:RDELTa? Return difference between MK1 and MK2.

FETCh[1|2|3|4|5|6|7]:MARKer:RRATio? Return ratio between MK1 and MK2 as a percentage.

FETCh[1|2]:TEMPerature:AVERage? Return average sensor internal temperature in degrees C

FETCh[1|2]:TEMPerature:CALTemp? Return sensor calibration temperature in degrees C

FETCh[1|2]:TEMPerature:CURRent? Return current sensor calibration temperature in degrees C

HCOPy:BACKground:COLor Set/return the background color used for printing the screen display. <args> = BLACK,

WHITE, GRAY

INITiate:CONTinuous Set/return state of mode which triggers meas cycles continuously. <arg> = ON, OFF

INITiate[:IMMediate[:ALL]] Set mode which starts a measurement cycle when trigger event occurs

MARKer[1|2]:ASSIgn Assign channel number to marker. <arg> = ACTIVE, CH1, CH2, TRIG1, TRIG2,

CHM, MEM1, MEM2

MARKer:GROUp Sets marker group. <arg> = BOTH, EACH

MARKer:MATH:BOTH Set marker group to both and delta marker, marker math, and units. (Ex: <args> =

RATIO MK1MK2 DBM)

MARKer:MATH:EACH Set marker group to each and delta marker, marker math, and units. (Ex: <args> =

RATIO MK1MK2 DBM)

MARKer[1|2]:POSItion:PERcent Set/return marker position in percent for selected window. <arg> = 0 through 100

MARKer[1|2]:POSItion:PIXel Set/return marker position in pixels for selected window. <arg> = 0 through 500

MARKer[1|2]:POSItion:TIMe Set/return marker time relative to the trigger. Enter time in seconds. (Ex: enter 1ms

as 0.001)

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 371 372

Sem comentários

Boonton 4500B Peak Power Meter Manual do Utilizador Página 302