Boonton 4240 RF Power Meter Manual do Utilizador descarregar pdf (Página 26)

Boonton 4240 Series RF Power Meter

Figure 3-1. Standard 4240 Series RF Power Meter - Front Panel

Table 3-1 Operating Controls, Indicators and Connections

Reference #

Front Rear Nomenclature Function

1 1 Internal Calibrator The output of the built-in 50MHz programmable calibrator is available from a

Type-N connector located on the front, or optionally on the rear panel of the

instrument. This calibrator is used to automatically calibrate sensor offset and

linearity, and can also be used as a general purpose calibration signal source.

2 2 Channel Inputs One or two Channel inputs are located on the front, or optionally on the rear

panel of the instrument. These are 10-pin precision connectors designed to accept

only Boonton CW power sensors.

Caution Do not attempt to connect anything other than a

Boonton power sensor and sensor data adapter to the Channel inputs!

The Channel inputs are not measurement terminals and cannot be used

for other than the intended purpose.

3 Display Screen LCD readout of the measurements and user interface for editing of the

instrument's operating parameters.

Getting Started

3-2

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 127 128

Sem comentários

Boonton 4240 RF Power Meter Manual do Utilizador Página 26