Boonton 52000 Series USB CW Power Sensor Manual do Utilizador descarregar pdf (Página 22)

22 Hardware Connections

Connection to your unit under test (UUT)

The 52000 series CW power sensor/meter has a standard SMA-m

connection port.

The recommended torque for the SMA-m connection is 5 lbs/in (0.5 Nm).

Refer to Figure 16 “Typical sensor to UUT connection” on page 22 for

a diagram of the sensor connection.

Figure 16 Typical sensor to UUT connection

Caution Do not turn the body of the sensor when connecting the

sensor to a unit under test (UUT). To avoid internal sensor damage,

connect and disconnect the sensor by turning the metal nut only.

Caution Ensure that you do not apply any excessive force on the

sensor once it has been connected.

Unit Under Test (UUT)

Test signal source

Your PC

USB

Cable

Signal cable

52000 Sensor

52012 CW Power Sensor

ESD

Earth ground must be connected

Max pwr +23dBm avg, +30dBm peak for 1us +/- 10.0VDC Max.

10MHz - 12.4GHz

10nW - 100mW (-50dBm to 20dBm)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Sem comentários

Boonton 52000 Series USB CW Power Sensor Manual do Utilizador Página 22