Boonton 52000 Series USB CW Power Sensor Manual do Utilizador descarregar pdf (Página 13)

Boonton 52000 Series 13

2 USB Installation

This chapter explains the process for installing and enabling the USB

drivers for your 52000 series CW power sensor/meter. These drivers

are required to enable effective measurement data Transfer.

There are two USB driver installation procedures covered in this

chapter – one for Windows® XP SP1 and the other for Windows® XP

SP2. To identify which operating system you have on your PC, refer to

“How to identify your PC operating system” on page 55.

Driver installation with Windows® XP SP2

This section describes how to install and congure your USB drivers

on a PC with Windows® XP and service pack 2 (SP2) operating

system.

Caution Do not connect your sensor and install the USB drivers

unless you have installed the Boonton software. Refer to “Installation

Of Software” on page 9 for more information.

1. Connect your sensor to the USB port of your PC. The Windows

Hardware Wizard starts automatically.

Refer to “How to connect your sensor” on page 21 for more

information.

2. Choose “No not at this time” and select Next.

Refer to Figure 7 on page 14.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Sem comentários

Boonton 52000 Series USB CW Power Sensor Manual do Utilizador Página 13